Eagle Mountain Foundation Pros logoEagle Mountain Foundation ProsFoundation Repair · Eagle Mountain, UT
Driveway Lifting photo

Eagle Mountain Foundation Pros

Driveway Lifting in Eagle Mountain, UT

Driveway lifting in Eagle Mountain, UT with polyurethane foam injection to raise sunken slabs near the garage, free estimate included.

  • 15+ Years local experience
  • 500+ Projects completed
  • Licensed & Insured

Serving Eagle Mountain and nearby communities.

A driveway sinking near the garage apron isn't cosmetic, it's usually a void opening up underneath from freeze-thaw cycling common across Utah Valley winters. Once that gap forms, the slab keeps settling until something fills the space back in.

Eagle Mountain Foundation Pros lifts sunken driveway slabs with polyurethane foam injection through small drilled access holes, restoring the slope needed for proper drainage without tearing out and repouring the whole driveway.

What's included

What's included with Driveway Lifting

Optional Customer prep

  • Typically included — Slab assessment and slope measurement -.
  • Access hole drilling at key points — Polyurethane foam injection and slope correction - Hole patching and joint resealing.
  • Full joint resealing along the driveway length
  • Surface sealant application after lifting
  • Grading correction if runoff is contributing to the sink
  • Move vehicles off the driveway before the scheduled visit
  • Note where water pools after it rains
  • Point out how long the sinking has been getting worse

How it works

How our Driveway Lifting process works

  1. Driveway Inspection photo
    Step 1

    Driveway Inspection

    Sunken or sloped sections are identified and measured for lift amount.

  2. Access Drilling photo
    Step 2

    Access Drilling

    Small holes are drilled at strategic points along the low areas.

  3. Foam Injection photo
    Step 3

    Foam Injection

    Polyurethane foam is pumped beneath the slab to raise it evenly.

  4. Slope Correction photo
    Step 4

    Slope Correction

    The surface is adjusted so water drains away from the garage again.

  5. Hole Sealing photo
    Step 5

    Hole Sealing

    Drilled holes are patched to blend into the existing driveway surface.

  6. Surface Review photo
    Step 6

    Surface Review

    The driveway is checked for even, stable elevation across every panel.

Materials

Materials and methods for Driveway Lifting

Garage aprons take the brunt of freeze-thaw cycling, which is why foam injection has replaced older lifting methods for driveway work here.

  • Polyurethane Foam photo

    Polyurethane Foam

    Lifts the slab without the added soil load that heavier mudjacking slurry puts on already-shifting ground.

  • Concrete Patch Mix photo

    Concrete Patch Mix

    Seals the access holes so the repair blends into the driveway surface.

  • Joint Sealant photo

    Joint Sealant

    Reseals expansion joints disturbed during the injection process to keep water out.

  • Surface Sealer photo

    Surface Sealer

    Guards the lifted slab against the moisture cycling that caused the original sink.

  • Leveling Equipment photo

    Leveling Equipment

    Confirms accurate elevation across the full driveway width during the lift.

  • Bonding Primer photo

    Bonding Primer

    Improves how well the patch material grips the original concrete.

Timeline

How long does a Driveway Lifting take?

Most driveways are drivable again the same day the work is done.

  1. 01

    Assessment

    same day
  2. 02

    Drilling and injection

    2–4 hours
  3. 03

    Cure time before driving

    1 hour

    about

  4. 04

    Final patching

    same visit

Need a schedule that fits?

Get a Free Estimate

Before & after

Before and after Driveway Lifting results

  • Driveway Lifting photo
    Before
  • Driveway Lifting photo
    After

FAQs

Driveway Lifting FAQs

Why is my driveway sinking near the garage?

Freeze-thaw cycling compacts the soil under the slab unevenly over time, and the garage apron takes the most weight and moisture exposure, so it's usually the first section to show a sink.

Is polyurethane foam lifting better than mudjacking for my driveway?

Foam cures in about an hour, adds far less weight to already-shifting soil, and holds up better against repeated freeze-thaw cycles than traditional mudjacking slurry.

How much does driveway lifting cost in Eagle Mountain?

Pricing depends on driveway size and how many sunken sections need injection. It typically runs a fraction of a full driveway replacement.

Do I need a permit to lift my driveway?

Foam lifting is non-structural and usually doesn't require one. A full driveway replacement is a separate project that might.

Can I fix a sunken driveway myself with a patch kit?

Surface patch kits fill the visible dip but don't address the void underneath, so the same spot usually sinks again within a season or two.

Next step

Get a Driveway Lifting estimate in Eagle Mountain

Call (435) 296-4086 or request a free estimate. We'll check the sink and the slope before any hole gets drilled.

Ask about Driveway Lifting

Tell us about the project and how to reach you.

Call (435) 296-4086