Eagle Mountain Foundation Pros
Concrete Lifting in Eagle Mountain, UT
Concrete lifting in Eagle Mountain, UT using polyurethane foam injection to raise sunken slabs, free estimate included.
- 15+ Years local experience
- 500+ Projects completed
- Licensed & Insured
Serving Eagle Mountain and nearby communities.
Freeze-thaw cycles settle concrete slabs unevenly over time, and once a void opens up underneath, the slab sinks until something fills that gap. Polyurethane concrete lifting fills it fast, raising the slab back to grade through a handful of dime-sized drill holes instead of tearing the whole section out.
Eagle Mountain Foundation Pros uses hydrophobic polyurethane foam injection for driveways, patios, and sidewalks, not mudjacking slurry, because the foam cures faster, weighs less, and doesn't wash out the way old-style mud mixes do.
What's included
What's included with Concrete Lifting
Optional Customer prep
- Typically included — Slab assessment and void measurement -.
- Drilling of access holes — Polyurethane foam injection and elevation monitoring - Hole patching and surface finish.
- Joint resealing around the lifted slab
- Drainage slope correction where water was pooling
- Companion drain or grading work if runoff caused the sinking
- Clear vehicles or furniture off the affected slab
- Note how long the area has been sinking
- Point out any drainage issues tied to the low spot
Want a clearer scope?
Get a Free EstimateHow it works
How our Concrete Lifting process works
Step 1Surface Assessment
Sunken or sloped concrete areas are measured for how much lift is needed.
Step 2Drilling Access Holes
Small, dime-sized holes are drilled into the slab for injection access.
Step 3Material Injection
Hydrophobic polyurethane foam is pumped beneath the slab to raise it evenly.
Step 4Elevation Monitoring
Lift height is tracked in real time to avoid over-raising the slab.
Step 5Hole Patching
Drilled holes are filled and finished to blend with the surrounding concrete.
Step 6Final Inspection
The lifted slab is checked for level and proper drainage slope.
Materials
Materials and methods for Concrete Lifting
Freeze-thaw winters create the voids under slabs that polyurethane foam is built to fill, without the weight and wash-out issues of older mudjacking methods.
Polyurethane Foam
Expands beneath the slab within minutes, lifting it without adding the extra soil load that heavier fill materials would.
Injection Ports
Placed at calculated spacing so foam spreads evenly rather than lifting one corner higher than the rest.
Patch Compound
Seals the small access holes left behind, close to invisible once finished.
Surface Sealant
Protects the lifted slab from the moisture cycling that caused the original sinking.
Leveling Gauge
Tracks lift in real time so the slab stops exactly at grade, not above it.
Bonding Agent
Helps the patch material grip the original concrete so holes don't reopen later.
Questions on materials?
Get a Free EstimateTimeline
How long does a Concrete Lifting take?
Foam lifting is one of the faster fixes on the list, often done and drivable the same day.
- 01
Assessment
same day - 02
Drilling and injection
1–2 hoursper slab section
- 03
Cure time before use
1 hour15 minutes to
- 04
Final patching
same visit
Need a schedule that fits?
Get a Free EstimateBefore & after
Before and after Concrete Lifting results
Before 
After
FAQs
Concrete Lifting FAQs
Is polyurethane foam lifting better than mudjacking for my driveway?
Foam cures in minutes instead of days, weighs a fraction of mudjacking slurry so it doesn't add extra load to unstable soil, and doesn't break down with repeated freeze-thaw cycles the way old-style mud mixes can.
How much does concrete lifting cost in Eagle Mountain?
Cost depends on slab size and how much void needs filling. Foam lifting typically runs well under a full tear-out and replacement, we give you both numbers to compare.
Do I need a permit for concrete lifting?
Most foam lifting is non-structural slab leveling and doesn't need a permit. Full slab replacement is a different project that may.
How long before I can drive or walk on the lifted concrete?
Polyurethane foam reaches enough strength to handle weight within about 15 minutes, much faster than waiting days for a mudjacking slurry to set.
Can concrete lifting fix the reason the slab sank in the first place?
Lifting raises the slab back to grade, but if poor drainage caused the void, a french drain or grading fix alongside it helps prevent it from sinking again.
Next step
Get a Concrete Lifting estimate in Eagle Mountain
Call (435) 296-4086 or request a free estimate. We'll measure the sink and tell you if foam lifting is the right call.
More services
Other Foundation Repair services
Foundation Repair
Foundation repair in Eagle Mountain using steel push piers, helical piers, and crack injection, with free estimates.
Piering and Underpinning
Steel push pier and helical pier underpinning in Eagle Mountain for settled foundations, with free estimates.
Wall Stabilization
Wall stabilization in Eagle Mountain, UT using wall anchors and carbon fiber straps, with a free inspection before any work is scheduled.
Ask about Concrete Lifting
Tell us about the project and how to reach you.